Splitscreen RHD Throttle Kit - Butty's Bits

This throttle kit is a bolt on replacement of the original.

This accelerator pedal linkage upgrade kit from Buttys Bits for VW Splitscreen 55-67 right hand drive converts your throttle pedal from a worn vague on/off switch to a smooth progressive control and transforms the driveability of your bus.

This is a must have upgrade for your Splitscreen replacing the tired, worn and rusted original linkage system with a more positive feeling pedal linkage.

Fitting
Remove all the old parts cross shaft ,push rod from pedal and disconnect the throttle cable , then clean the 2 square lugs where the original cross shaft went through the 2 holders , the new kit fits over the 2 square lugs allowing 2 bearing carriers to hang just below the original holders (The kit has to be fitted as it comes assembled remove the mounting bolts and fit the square washer over the square lug then fit the square bearing holder over the same lug and bolt up leave loose while you set the cross shaft position then tighten up and make sure new assembly moves without rubbing or catching on any other components , then connect pedal then acc cable) , the bearings will give a far smoother feeling to your acc pedal . Also the end plates are 20mm taller than the standard setup so it allows full throttle to be achieved easier on twin carb`d hex bar setups, kit can be altered if you require less cable travel .